What Dishwasher Not Drying means (miele dishwasher not drying)
When a miele dishwasher not drying is the complaint, it is an observable condition rather than a code — dishes finish damp. Many Miele models dry with AutoOpen (the door pops ajar at the end) plus residual heat, so settings, rinse aid, and loading often explain wet dishes more than a fault.
Symptoms to look for
The signs below help confirm you are dealing with this condition rather than a different fault on your Miele Dishwasher. You may see one of them or several together, and they can build up gradually or appear suddenly after a power event, a long door opening, a spill, or recent service.
- Dishes, especially plastics, finish damp
- The AutoOpen door does not pop ajar at the end
- Water pools in cups and recesses
- Glassware shows spots as it air-dries
Common causes
Several different faults can produce these symptoms. Working through the most likely causes in order helps separate a quick, owner-level check from a problem that needs trained service and the correct Miele parts.
- AutoOpen blocked — a cabinet or item stops the door opening
- Low or empty rinse aid — water does not sheet off
- Wrong program/option — an eco or short cycle dries less
- Loading issues — cups trap water; plastics hold moisture
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where high-voltage parts, gas, the sealed refrigeration system, or a heat-pump compressor are involved, and hand the rest to a qualified technician.
- Allow the AutoOpen door to pop ajar at the end — do not block it with cabinetry or items.
- Refill rinse aid and set the dosage for your water.
- Choose a program with a stronger drying option where available.
- If dishes stay wet with rinse aid and AutoOpen working, book service to check the heater.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the autoopen door mechanism, heating element, rinse aid dispenser, and vent. The correct part for your Miele Dishwasher is matched from the model and serial number, and genuine Miele components are fitted through trusted parts suppliers rather than generic substitutes so that performance, safety, and the appliance’s long working life are all protected. Confirming the failed part before ordering avoids replacing more than the fault actually requires.
When to call a technician
Persistent wet dishes despite rinse aid, correct loading, and a working AutoOpen door need a technician to test the heating and drying system. When the fix calls for trained service, book a visit through our scheduling page and an experienced, qualified technician will diagnose and repair it.
Prevention and care
Regular care keeps this condition from returning on your Miele Dishwasher. Keep filters, vents, seals, and the condenser, exhaust, or burner path clean, avoid overloading or blocking airflow, check that doors and seals close cleanly, and follow the Miele maintenance guidance for your model. Note when the symptom first appeared and what changed around the same time — a recent load, a warm room, a power event, a spill, or recent service — because that detail often points a technician straight to the cause and keeps the repair simple.
Related help and Miele resources
Browse other Miele Dishwasher diagnostics, read about Miele Dishwasher repair, look up your unit in the Miele models reference, or the related F25 heating fault, or schedule a service visit. For Miele manufacturer documentation and model lookup, visit the manufacturer at mieleusa.com.
If the condition persists after the owner checks above, an experienced Miele technician can read the full fault history, test each named component against specification, and fit genuine Miele parts so the dishwasher returns to its proper performance. Most visits resolve the issue in a single trip, and the work is backed by a 30-day labor warranty on the workmanship.
